Batteries, Battery Disconnect Kits & Battery Cable Kits

Part # 85-264

3/8″ Stud battery cable end for 1/0 cable

Part# 85-254-3

Are you looking for a safe and secure junction point to tie in your switch panel feed or make a more convenient disconnect point for your starter cable? If so, SW Has the junction block for you! Small in size with molded in bolt tabs, this block features a 3/8″ stud and a self-insulating Bakelite base cover

Part# 85-253

PLUG IN TYPE AS USED ON MILLER WELDERS, 2 MALE, 2 FEMALE

Part# 60-346

WORKS with RED YELLOW TOP OPTIMA BATTERY MAX BATTERY SIZE 10″WIDE X 7″DEEP X 6-3/4″TALL BATTERY SITS ON ALUM PLATE THAT BOLTS TO FLOOR OR CHASSIS BATTERY IS HELD IN PLACE with ALUM POST STRAP MOUNTING HARDWARE INCLUDED

Part# 85-C4029

Moroso # C4029, 12 3/8″ LONG,  X 9 3/4″ WIDE X 10″ HIGH. 1/8″ THICK MILD STEEL, INCLUDES 3/8″ HOLD DOWN ROD AND GROMMETS, FITS SERIES 24 BATTERY

Part# 85-252

# 74140, BATTERY CHARGING POSTS W/ PROTECTIVE CAPS FOR CHARGING BATTERY WITHOUT OPENING HOOD 1 PAIR PER PACK

Part# 85-404

1200 5 second cranking amps, 630 Cold Cranking AMPS
3 Year Warranty – XRP
90 Minute Reserve Power
May be used in any Position
Length  7-13/16″ Width 6-9/16″ Height 7-7/16″
37 lbs

Part# 85-417

50 AMPS – Dual Output For Systems With or Without Alternators

Part# 85-262

straight cable end for 1/0 cable

Part# 85-416

XS POWER # HF1516.  12 Volt and 16 Volt Batteries, Three Charging Modes: Compatible with Lead, Acid Type Batteries Including AGM/GEL, Deep Cycle, Maintenance Free. Three Charging Levels: 2A, 15A and  25A Rapid Charge