| Weight | 75 lbs |
|---|---|
| Dimensions | 70 × 12 × 12 in |
Stock Replacement/Bolt In, Rear Axle Housings, S&W Made Parts
2005-2014 Mustang Fabricated 9″ Ford Housing 2″ Narrowed
Part# 45-447FAB
2″ narrower than stock. Replaces stock 8.8 rear housing, uses late model big Ford ends (45-1137), shock control arm brackets in stock location, lower control arm brackets have additional holes, center pinion, 58-1/4″ housing end to housing end, 63-1/4″ axle flange to axle flange, for upper control arm hardware use 45-445H. Has brace mounts for anti-roll bar kit 40-708K
If using factory brakes, need to purchase 45-044 kit-
$1,519.95
Upgrades
Product Q&A Ask a Question
Success!
Question Added Successfully
Sort by
-
This product has no questions.
Related products
-
S&W Made Parts, Chassis & Blueprints, Blueprints
Blueprint – 225″ Advanced ET Dragster with Soild Mount Rear
S&W Made Parts, Chassis & Blueprints, BlueprintsBlueprint – 225″ Advanced ET Dragster with Soild Mount Rear
Part# 05-001-AET-BP
Assembly blueprint with cut list for 225″ wheelbase ADVANCED ET dragster with solid mount rear. Meets SFI spec 2.5B for rear engine dragster 6.00 to 7.49 seconds .. NOTE – assembling a drag race vehicle form a blue print is not for beginners and should only be attempted by a skilled and experienced fabricator
SKU: 05-001-AET-BP -
Stock Replacement/Bolt In
55-57 Chevy Complete 9″ Ford Big Bearing Bolt In Rear
Part#45-615
55-57 CHEVY COMPLETE 9″FORD BIG BEARING BOLT IN REAR: COMES WITH ALL NEW U.S. MADE HOUSING, NEW 31 SPLINE HIGH PERFORMANCE AXLES, SPRING PERCHES, BRACKETS AND TABS, TRU TRAC THIRD MEMBER WITH DESIRED RATIO, SUPER LIGHT IRON NODULAR CASE, NEW PINION YOKE, BEARINGS, STUDS, ALL FASTENERS, AXLE SEALS, HOUSING VENT.AND FORD 10″ DRUM BRAKES
SKU: 45-615 -
Stock Replacement/Bolt In, Rear Axle Housings, S&W Made Parts
Fabricated 9″ Ford Housing Stock Width For 2005-2014 Mustang
Stock Replacement/Bolt In, Rear Axle Housings, S&W Made PartsFabricated 9″ Ford Housing Stock Width For 2005-2014 Mustang
Part# 45-447FAB
Replaces stock 8.8 rear housing, uses late model big Ford ends (45-1137), shock control arm brackets in stock location, lower control arm brackets have additional holes, center pinion, 60-1/4″ housing end to housing end, 65-1/4″ axle flange to axle flange, for upper control arm hardware use 45-445H. Has brace mounts for anti-roll bar kit 40-708K.
Note: for 2″ narrower, use part# 45-448FAB
If using factory brakes, need to purchase 45-044 kit-
SKU: 45-447FAB
