Upper Shock Crossmember

Designed for use with Upper Eye Mount Shocks.

36″ long 1-5/8″ x .134″ Wall Mild Steel Crossmember

All tabs and hardware included.

Welding required for installation.

Bill of Materials

Installation Instructions

1. Level car front to rear and side to side with rear housing at ride height.

2. Set the shocks at their installed height, with the spring removed.

3. Attach the shock to the bottom shock mount. Stand the shock vertical in the car. Make sure it is vertical both front to rear and side to side. When locating the top shock mounts make sure there is enough clearance around the shock so that the spring does not hit the frame or any suspension component when moving throughout it's entire suspension travel.

4. Install mounting tabs on upper shock eye. Use of half moon spacers may be necessary with some shocks.

5. Measure the distance between the frame rails above the shocks. Cut the crossmember tube to this length.

6. Tack weld the crossmember tube in place between the frame rails and on top of the shock mounting tabs. Crossmember can also be located in front of the shock mounting tabs. Remember to keep the shocks vertical both front to back and side to side.

7. Install the springs on the shocks. Mount shocks and check all clearances.

8. If all clearance are OK, remove shocks and springs and finish welding on mounting tabs and crossmember.